...Allbatman.com..

The Site to Rebuild and Restore the Corgi 267 Batmobile

PAINTING TIPS.

             1:    A painting booth can be made from a cardboard box cut down .

             2:    Always paint your models in a well ventilated place and ALWAYS

                    wear a dustmask and safety glasses.            

              3:   Spray cans are very good to use, but always warm them first by

                    putting them in warm water before you use them.

              4:   Always apply a primer coat first  spray on lightly, so you don't loose detail.

                    Hold the spray 6 inches from the model and lightly spray.

              5:   Start the spray can spraying before the start of the model, go from side to side

                   and don't stop till you have  gone past the model,  building up light coats

                    of primer as you go..

              6:   Let the primer dry out compleatly [till you can't get any more fumes off it!]

                    Same for the main paint coats.Always leave a good length of time

                    between each coat of paint..

                   Clear coat is the same as above ,you can also sand the clear coat

                   with fine wire wool or sandpaper ,

                   Very fine surface scratches  will disappear like magic ! with the last coat of clear.

               7:  Small bits and pieces can be either taped or glued to small sticks

                     and then stuck in to a  suitable material like aeroboard or the foam base

                     you can get for flowers

                    .

       See you later! Thanks for looking.

APPLYING DECALS..

Decals can make or break a model, they often have a excess clear bit around them

which dosn't look great when they dry but you can cut this off with a sharp knife before you

put the decal in the water to apply it .I always wet the model a bit first where the decal will be going.

Decals stick to shiny surfaces best.  If you are applying decals to a  model  that is painted in flat

colors apply a coat of Gloss Coat then apply your decals.  Once the decals have set apply a coat of Dull Coat;

Always remember if you have a lot of decals to put on the model , do a few at a time let them dry

then do a few more . do this till you finish .

 

HERES A LIST OF TOOLS THAT I USE

  A dremmel drill. I have two of these ,one is cordless this one is very handy.

  A set of paint brushes, assorted.

  A set of needle files.

  A scalpel set.

  A good set of drill bits

  A magnifying glass

  Superglue

  A parts box [very important]  

  A candle.

  Paint [black ,red ,silver , etc humbrol model paint is good ]

  Car touch up paint ,[black , red]

  Spray paint [ car paint,, primer , matt black ,gloss black , clear coat]

  Masking tape. [3mm]

  Soldering iron.

  Small set of screwdrivers

  Surgical gloves.

  A table vice.

  A small vice grips.

  A long and a short nose pliers .

  A box of tooth picks.

  A  face mask. and safety glasses .[IMPORTANT]

 

Lots of patience !

 

You don’t need all of the above but it helps.

 

 

 

TO FIND THE BEST BODY BUILDING, BODY TONING AND WEIGHT LOSS PROGRAMS GO TO .. http://resources-for-healthy-living.com

{ParagraphsSidebar}